Saturday, September 19, 2020

Section 56 Garmin Autopilot Roll Servo

 RV14 Build August

Garmin AutoPilot Servos

This was one of the few things that I thought would go relatively easy and did!

First I mounted it up and noticed I didn't like the way the wires came in so I flipped the molex which required making the mounting bracket a little larger.




Then I had to make the pushrod.



A few attempts to install the hardware correctly and done.



Section 56 Garmin Autopilot Roll Servo 6.5 Hours


at
Labels: , , , ,

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Before Start and First flight testing

 R14 Build August & September 21 Testing Getting into the fun stuf!! Putting gas in for the first time. Have the airplane up to get 15 d...

  • Rudder and Vertical Stabilizer
    I got to the shop everyday last week! I feel like I made a ton of progress. I finished the rework of the Vertical Stabiler parts that I had ...
  • Before Start and First flight testing
     R14 Build August & September 21 Testing Getting into the fun stuf!! Putting gas in for the first time. Have the airplane up to get 15 d...
  • Section 38 Rear Window Install
     RV14 Build August 21 Canopy and Window I waited on the rear window install to make it easier to get in and out of the plane to work. Now th...
  • Section 29: Pro Seal air vents
     Rv14 Build June 21 Air Vents The plans have you wait on the air vents till after the panel is in to make sure everything fits correctly. So...
  • Avionics LRU Installs and Programming
     RV14 Build August 21 Avionics Install and Programming Now that the wings are on time to install the Pitot luckily I was smart enough to run...
  • Reiff heater Install
     RV14 Build June 21 FWF Wiring Reiff I wanted to install the full REIFF XP heater kit, but on the IO-390C sump there isn't a flat place ...