Thursday, September 16, 2021

Avionics LRU Installs and Programming

 RV14 Build August 21

Now that the wings are on time to install the Pitot

luckily I was smart enough to run the wires and tube long enough so everything pulls through the pitot mast.

Running the wire for the OAT.

Pinning the OAT

All set!

Screws have a little lock tight on them and the pito tube is installed! Making progress feels so good!

Securing the service loops.

I installed the Pitot tube inboard of the tie down so I didn't have to worry about it interfering with the tie down ropes. But this cause a new issue to make sure I wasn't interfering with the push rods. Little bending of the pitot and AOA tubes and the routing worked great.

Installed my hidden starter switch power.

Right now just with velcro until im sure I want it here.

The pilot stick has having a loose wiring issue so i cut and repinned the harness.

Pins installed.

Programming the G3X indications.



Oil pressure



LRU Install and avionics Program 20.0 Man Hours


at
Labels: , , ,

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Before Start and First flight testing

 R14 Build August & September 21 Testing Getting into the fun stuf!! Putting gas in for the first time. Have the airplane up to get 15 d...

  • Rudder and Vertical Stabilizer
    I got to the shop everyday last week! I feel like I made a ton of progress. I finished the rework of the Vertical Stabiler parts that I had ...
  • Before Start and First flight testing
     R14 Build August & September 21 Testing Getting into the fun stuf!! Putting gas in for the first time. Have the airplane up to get 15 d...
  • Section 29: Pro Seal air vents
     Rv14 Build June 21 Air Vents The plans have you wait on the air vents till after the panel is in to make sure everything fits correctly. So...
  • Section 38 Rear Window Install
     RV14 Build August 21 Canopy and Window I waited on the rear window install to make it easier to get in and out of the plane to work. Now th...
  • Reiff heater Install
     RV14 Build June 21 FWF Wiring Reiff I wanted to install the full REIFF XP heater kit, but on the IO-390C sump there isn't a flat place ...
  • Avionics LRU Installs and Programming
     RV14 Build August 21 Avionics Install and Programming Now that the wings are on time to install the Pitot luckily I was smart enough to run...