Tuesday, November 12, 2019

Wrap up Section 25

RV14 Build October 26

FWD MID Fuselage Bulkheads

I had realized i missed the 2 side angles for the forward center section bulkhead and had to ream the holes in the 2 bulkheads still, didn't get any pictures of that unfortunately.


After reading the plans again there is a note on 25-05 "The outboard most cover ribs are attached using only one bolt at this time." I started to wonder if this meant don't install the second bolt but it was okay to rivet the cover ribs on still, after talking to Vans that turned out to be the case. So added the rivets and now section 25 is done!

FWD MID Fuselage Bulkhead 2 Hours

at
Labels: ,

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Before Start and First flight testing

 R14 Build August & September 21 Testing Getting into the fun stuf!! Putting gas in for the first time. Have the airplane up to get 15 d...

  • Rudder and Vertical Stabilizer
    I got to the shop everyday last week! I feel like I made a ton of progress. I finished the rework of the Vertical Stabiler parts that I had ...
  • Before Start and First flight testing
     R14 Build August & September 21 Testing Getting into the fun stuf!! Putting gas in for the first time. Have the airplane up to get 15 d...
  • Section 29: Pro Seal air vents
     Rv14 Build June 21 Air Vents The plans have you wait on the air vents till after the panel is in to make sure everything fits correctly. So...
  • Section 38 Rear Window Install
     RV14 Build August 21 Canopy and Window I waited on the rear window install to make it easier to get in and out of the plane to work. Now th...
  • Reiff heater Install
     RV14 Build June 21 FWF Wiring Reiff I wanted to install the full REIFF XP heater kit, but on the IO-390C sump there isn't a flat place ...
  • Avionics LRU Installs and Programming
     RV14 Build August 21 Avionics Install and Programming Now that the wings are on time to install the Pitot luckily I was smart enough to run...